|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual is well organized and is easy to read. The chapters are following normal way to proceed.
;
This scanned manual is well done in that most all the pages except for one is straight and clear- the way I would do them. One page was upside down but that happens. For the money that is charged on this site you get a pretty good deal. Now with complex repairs, I still prefer to us paper manuals which I have to buy at stereomanuals but the one I got here was much less than the $45 he was charging but this is a larger than normal manual for three different units. I am a picky manual user because I have used original manuals from Sony and Teac.
;
Very useful service manual, was exactly what i needed.Good quality,reasonable price.Thank you.
;
Acurate informations inside the SM and I could repair my old Sansui SC-3330 without any problems. Thanks.
;
I used it to repair a NAD 7030, but unfortunately, the 7045 is different !
But documentation was useful.
and the back resistance should r e a d approximately 3 megohms or more. To get a true reading of the forward resistance an ohmmeter equipped with approximately a 100 volt battery should be used. This arrangement will give a low forward resistance reading and essentially the same back resistance, i f the unit is in good condition.
4 -4
ADJUSTING THE OSCILLOSCOPE VERTICAL AND HORIZONTAL POSITIONING The trace on the front panel oscilloscope is adjusted to center by horizontal positioning control R32 and vertical positioning control R34 (see Figure 18.)
-
4 -5
CALIBRATING THE MAIN TUNING DIAL Following replacement of r - f oscillator tube V 1 and V2, the high frequency end of the main tuning dial may be slightly out of calibration and the oscillator circuit may be capacitively out of balance. To recalibrate the tuning dial and bring the circuit back into balance, proceed as follows: a. Using a 20,000 ohm/volt d-c meter measure the voltage obtained at the MIXER OUTPUT jack. This voltage should range from approximately 1.75 vdc at 100 megacycles to 2.2 vdc at 200 megacycles. If this voltage i s too low, t r i m m e r capacitors C3 and C28 on the top of the r-f oscillator housing must be adjusted to peak this voltage. Front panel patch cords must be in position for this measurement. Connect the front panel FREQ. METER jack to the 525B input to measure the frequency of the 540A oscillator. Check the total frequency range of the oscillator: should be 1 0 0 to 220 megacycles. Set the main tuning dial to 200 and note frequency indication on the Counter. If the frequency i s not 200 megacycles, readjust C3 and C28 to bring frequency to 200 megacycles, making sure that balance of the two t r i m m e r capacitors is such that the d-c voltage r e a d on the voltmeter is peaked for any particular frequency setting. Check major calibration on frequency dial and refine the above adjustments for best overall accuracy.
b.
C.
d.
e.
.
4 -4
|
|
|
> |
|
